|
plate terminal strip are undisturbed. Loosen weather-
tight connector on shielded housing. Route conduit
assembly wires through weathertight connection and
into housing. Secure weathertight connector. 2.5 Refer to Figure 2.4. Loosen alien screw on back of housing and install green ground wire fork terminal under screw and retighten. Important: The limit switch bracket must not be moved during ground wire installation. Loosen |
alien screw only enough to allow insertion of fork terminal. Cut wires to length of 4 to 4-1/2". Strip about 1/4" of insulation from wires. Attach wires to terminals on cover plate as shown. Check all terminal connections. Replace housing cover plate making sure all wiring is inside housing. Install four cover plate screws and fully tighten. |