Installation Instructions
Radome Hardware Kit
for P Series Standard Antennas
 Bulletin 23709C
Description
This kit includes the clips, clamps, and bolt hardware for attaching a radome to the rolled reflector rim of a standard antenna. The kit parts differ slightly according to the size of the antenna as shown in the illustrations.
Notice
The installation, maintenance, or removal of antenna systems requires qualified, experienced personnel. Andrew installation instructions have been written for such personnel. Antenna systems should be inspected once a year by qualified personnel to verify proper installation, maintenance, and condition of equipment.

Andrew disclaims any liability or responsibility for the results of improper or unsafe installation practices.

1 Tightly attach the clips around the radome riim with two bolts and lock nuts per clip.
2 Loosely attach clamps to the clips with bolts, flat washers, and lock nuts.
3 Position the radome against the reflector rim with the flash trademark properly aligned as shown. Position all clamps behind the reflector rim and then tighten the clamp bolts.



Andrew
Corporation 		Telephone:
708-349-3300 		Customer Service, 24 hours: U.S.A. * Canada *
Mexico: 1-800-255-1479
10500 West
153rd Street 		FAX (U.S.A.)
1-800-349-5444 		U.K. 0800 250055 * Republic of Ireland:
1 800 535358
Orland Park, IL
U.S.A. 60462 		Internet:
http://www.andrew.com 		Other Europe: +44 1592 782612
Page 1 of 1