2.4 Refer to Figure 2. Place opposing match-marked
reflector segments (AB and DE) on temporary supports
with concave sides down. Raise reflector segments and
loosely attach 202429 mounting ring hub to outside (convex
side) of reflector vertex opening using 1/4-20 capscrews,
lock washers and nuts. Insert capscrews from
inside (concave side) of reflector segments. Note:
Reflector segments will require temporary center support>

2.5 Loosely attach diameter setting bands to outer edges
of opposing reflector segments using 49424 edge joining
plates with capscrew hardware. Insert capscrews from inside
(concave side) of reflector segments. Note: Reflector
segments should be self-supporting at this point.

Click here to see the picture below magnified, Click Back button when finished
Figure 2
Figure 2
2.6 Refer to Figure 3. Place two adjacent match-marked
reflector segments (CD and AF) on temporary supports at
opposing positions. Raise reflector segments and loosely
attach to mounting ring hub and remaining portion of diameter
setting bands and edge joining plates using capscrew
hardware. Note: Use of supplied stick wax on setting band
hardware will ease later removal of setting band assembly.

1.2 The main reflector is segmented in a six-piece configu-
ration to reduce shipping volume and facilitate transport to
remote sites or rooftops.

2.7 Loosely attach 49693 joining plates inside reflector rim
and across all reflector seams. Note: Insert capscrews
from outside reflector rim.

2.8 Place additional match-marked reflector segment (EF)
on temporary support and loosely attach to mounting ring
hub and diameter setting bands with corresponding seam
hardware and joining plates installed across reflector
seams as previously described. 		Click here to see the picture below magnified, Click Back button when finished
Figure 3
Figure 3
Page 1 of 6 -- Page 2 of 6 -- Page 3 of 6