1/4" Superflexible,
High-Temperature,
Expanded PTFE Dielectric
HELIAX® Coaxial Cables
50-ohm
ETS1-50 ETS1-50T
Types E5S1-50T and E%S1-50 are new 1/4"
superflexible HELIAX coaxial cables for high power or plenum
applications. ETS1-50T is jacketed; ETS1-50 is
unjacketed. Compared with Type FSJ1-50A, the jacketed
cable has over three times the power handling capability
at frequencies above 10 MHz, with comparable attenuation.
The unjacketed cable has even higher average
power ratings. Both are ideal for equipment room
jumpers that must interface with power transmitters.
The inner and outer conductor diameters of these cables
are the same as FSJ1-50A thus allowing the use of existing
connectors. Maximum operating frequency is 20.0 GHz.
High Average Power
Average power levels 50% greater than comparably-
sized PTFE braided cables; similar to much larger PTFE
braided cables. The low-loss expanded PTFE dielectric
handles 3.5 to 4 times the average power of foam PE
dielectric at 1 GHz.
Superior to Braided Cable
Attenuation levels only one third those of comparably-
sized PTFE braided cables; 50% lower than much
larger PTFE braided cables. Rugged, durable solid
copper outer conductor provides continuous RFI/EMI
shielding, minimizes interference and maximizes system
security.
|
Flexibility
1" (25 mm) minimum bend radius for easy installation
and routing in enclosed areas. Simplifies your system
design. Capable of numerous reverse bends.
High Performance in Applications
Such As:
Antenna and equipment room jumpers for land
mobile radio, cellular, paging and earth stations;
interrack and combiner cabling; RF test equipment.
Electronic warfare.
Military phased array radar; airborne and shipboard
radar systems; missile systems.
Operates up to 20 GHz
Ideal for electronic warfare, earth station and other high
frequency applications requiring low loss and high
power.
|
