Positioning Struts

 Struts should be positioned as close to zero
degrees (parallel to the horizon) in elevation as possible
when installed. Azimuth positioning should be parallel to
the path of the antenna. If this cannot be done, struts
may be positioned within the angular limits shown in the
illustrations.


Tightening Strut Clamp Assemblies

 Tighten the setscrews. Next, tighten the jam nuts
against the bracket and then tighten the clamp
mounting bolt.
 		Remove Excess Strut Length

 After the antenna is aligned and fully secured,
excess strut length should be removed as a personal safety
percaution. Cut off the strut approximately 305 mm (12")
beyond the strut clamp assembly. Apply cold galvanizing
compound to the cut end of the strut.

ANDREWNU
Andrew
Corporation 		Telephone:
708-349-3300 		Customer Service, 24 hours: U.S.A. * Canada *
Mexico: 1-800-255-1479
10500 West
153rd Street 		FAX (U.S.A.)
1-800-349-5444 		U.K. 0800 250055 * Republic of Ireland:
1 800 535358
Orland Park, IL
U.S.A. 60462 		Internet:
http://www.andrew.com 		Other Europe: +44 1592 782612
Page 3 of 4 -- Page 4 of 4